Water hardness

RG30 Reading

Harder than the UK average. Expect visible limescale on kettles and taps.

At 326 ppm, Reading sits among the UK's hardest water areas — compare it against the softest areas.

Very Hard 326 ppm South East Thames Water
Your reading
326
parts per million
Soft
Moderate
Hard
Very hard
0100200300400+

What this means for your home

Based on 326 ppm in Reading (very hard water).

  • Heavy limescale requiring frequent descaling
  • Blocked showerheads and reduced water flow
  • Substantially higher energy bills from boiler scale
  • Dry, itchy skin and lifeless hair
  • White crusty deposits on taps and surfaces
  • Reduced lifespan of washing machines and dishwashers
Heat loss
12%
Heavy scaling
Softener salt
£19–32
per year
Worth it?
Yes
at 326 ppm
Suggested for very hard water
Whole-house water softener
Best long-term protection for boilers and pipes.
From £600 installed
Shower head filter
A simple first step for limescale on tiles and glass.
From £25
Filter jug or under-sink
Improves taste and reduces kettle scale.
From £20
Softening

Should you soften the water in Reading?

A verdict and running-cost estimate based on RG30's 326 ppm reading, for a typical 4-person household.

Softener recommended

Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Recommended size
24k
grain capacity, regenerates ~every 8.2 days
Salt running cost
£19–32
per year (~67 kg salt)
Limescale
12%
est. heater efficiency loss. Heavy scaling
Soap saving
High
Large saving: many homes cut soap, shampoo and detergent use by up to half.

Appliance impact at 326 ppm: significant: elements fur up, expect earlier failures. Sized for a 4-person home; regenerates roughly every 8 days (estimate). Figures are conservative estimates and vary with household size and usage.

Water quality details

Hardness data for RG30

Sourced from Thames Water's published water-quality reports and public records.

Hardness measurements

Parts per million (ppm CaCO₃)326
Degrees Clark (°Clark)22.8
Degrees French (°fH)32.6
Degrees German (°dH)18.3
Calcium (mg/L Ca²⁺)131

Supplier and area

Water supplier Thames Water
Region South East
County Berkshire
Hardness band Very Hard
UK average 207 ppm
Visit Thames Water page
Official source
Thames Water Utilities Ltd water-hardness report

Read the hardness categories table to see where your supply falls; most of the region is hard to very hard at over 200 mg/l CaCO3.

Nearby

Other areas near Reading

RG29
Hook
302ppm
Very Hard
RG31
Reading
327ppm
Very Hard
FAQ

Common questions about RG30

What is the water hardness in RG30 Reading?
The water in RG30 Reading has a hardness level of 326 ppm (parts per million) calcium carbonate, classified as very hard. This is 119 ppm above the UK national average of 207 ppm.
Which water company supplies RG30?
RG30 Reading is supplied by Thames Water. Thames Water serves the South East region.
Is the water in RG30 safe to drink?
Yes. Very Hard water at 326 ppm is safe to drink. Water hardness affects taste and can cause limescale, but it is not a health risk. In fact, hard water contains beneficial minerals like calcium and magnesium.
How can I reduce water hardness in RG30?
For very hard water at 326 ppm, a whole-house water softener is the most effective solution. You can also use a jug filter for drinking water, descaling products for appliances, and a shower filter for better skin and hair.
What does 326 ppm water hardness mean?
326 ppm means there are 326 parts per million of calcium carbonate dissolved in the water. This is equivalent to 22.8 Clark degrees, 18.3 German degrees, or 32.6 French degrees. Water above 180 ppm is generally considered hard.
What size water softener do I need in RG30?
For a typical 4-person home at 326 ppm, a 24,000 grain softener is a sensible size. It would regenerate roughly every 8.2 days. Larger households or higher daily use need a bigger unit. These figures are conservative estimates.
How much does it cost to run a water softener in RG30?
At 326 ppm, expect to use about 67 kg of salt a year, costing roughly £19–£32/year. Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Fix hard water in Reading

Enter your email and we will send the limescale fixes that actually work at 326 ppm, plus what to skip.

Check another postcode

Compare hardness across areas before moving or buying a softener.