Water hardness

KT22 Leatherhead

Harder than the UK average. Expect visible limescale on kettles and taps.

At 344 ppm, Leatherhead sits among the UK's hardest water areas — compare it against the softest areas.

Very Hard 344 ppm London Thames Water
Your reading
344
parts per million
Soft
Moderate
Hard
Very hard
0100200300400+

What this means for your home

Based on 344 ppm in Leatherhead (very hard water).

  • Heavy limescale requiring frequent descaling
  • Blocked showerheads and reduced water flow
  • Substantially higher energy bills from boiler scale
  • Dry, itchy skin and lifeless hair
  • White crusty deposits on taps and surfaces
  • Reduced lifespan of washing machines and dishwashers
Heat loss
12%
Heavy scaling
Softener salt
£20–34
per year
Worth it?
Yes
at 344 ppm
Suggested for very hard water
Whole-house water softener
Best long-term protection for boilers and pipes.
From £600 installed
Shower head filter
A simple first step for limescale on tiles and glass.
From £25
Filter jug or under-sink
Improves taste and reduces kettle scale.
From £20
Softening

Should you soften the water in Leatherhead?

A verdict and running-cost estimate based on KT22's 344 ppm reading, for a typical 4-person household.

Softener recommended

Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Recommended size
24k
grain capacity, regenerates ~every 7.8 days
Salt running cost
£20–34
per year (~70 kg salt)
Limescale
12%
est. heater efficiency loss. Heavy scaling
Soap saving
High
Large saving: many homes cut soap, shampoo and detergent use by up to half.

Appliance impact at 344 ppm: significant: elements fur up, expect earlier failures. Sized for a 4-person home; regenerates roughly every 8 days (estimate). Figures are conservative estimates and vary with household size and usage.

Water quality details

Hardness data for KT22

Sourced from Thames Water's published water-quality reports and public records.

Hardness measurements

Parts per million (ppm CaCO₃)344
Degrees Clark (°Clark)24.1
Degrees French (°fH)34.4
Degrees German (°dH)19.3
Calcium (mg/L Ca²⁺)138

Supplier and area

Water supplier Thames Water
Region London
County Greater London
Hardness band Very Hard
UK average 207 ppm
Visit Thames Water page
Official source
Thames Water Utilities Ltd water-hardness report

Read the hardness categories table to see where your supply falls; most of the region is hard to very hard at over 200 mg/l CaCO3.

Nearby

Other areas near Leatherhead

KT21
Ashtead
343ppm
Very Hard
KT23
Leatherhead
345ppm
Very Hard
KT24
Leatherhead
346ppm
Very Hard
FAQ

Common questions about KT22

What is the water hardness in KT22 Leatherhead?
The water in KT22 Leatherhead has a hardness level of 344 ppm (parts per million) calcium carbonate, classified as very hard. This is 137 ppm above the UK national average of 207 ppm.
Which water company supplies KT22?
KT22 Leatherhead is supplied by Thames Water. Thames Water serves the London region.
Is the water in KT22 safe to drink?
Yes. Very Hard water at 344 ppm is safe to drink. Water hardness affects taste and can cause limescale, but it is not a health risk. In fact, hard water contains beneficial minerals like calcium and magnesium.
How can I reduce water hardness in KT22?
For very hard water at 344 ppm, a whole-house water softener is the most effective solution. You can also use a jug filter for drinking water, descaling products for appliances, and a shower filter for better skin and hair.
What does 344 ppm water hardness mean?
344 ppm means there are 344 parts per million of calcium carbonate dissolved in the water. This is equivalent to 24.1 Clark degrees, 19.3 German degrees, or 34.4 French degrees. Water above 180 ppm is generally considered hard.
What size water softener do I need in KT22?
For a typical 4-person home at 344 ppm, a 24,000 grain softener is a sensible size. It would regenerate roughly every 7.8 days. Larger households or higher daily use need a bigger unit. These figures are conservative estimates.
How much does it cost to run a water softener in KT22?
At 344 ppm, expect to use about 70 kg of salt a year, costing roughly £20–£34/year. Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Fix hard water in Leatherhead

Enter your email and we will send the limescale fixes that actually work at 344 ppm, plus what to skip.

Check another postcode

Compare hardness across areas before moving or buying a softener.