Water hardness

IP30 Bury St Edmunds

Harder than the UK average. Expect visible limescale on kettles and taps.

At 390 ppm, Bury St Edmunds sits among the UK's hardest water areas — compare it against the softest areas.

Very Hard 390 ppm East Of England Anglian Water
Your reading
390
parts per million
Soft
Moderate
Hard
Very hard
0100200300400+

What this means for your home

Based on 390 ppm in Bury St Edmunds (very hard water).

  • Heavy limescale requiring frequent descaling
  • Blocked showerheads and reduced water flow
  • Substantially higher energy bills from boiler scale
  • Dry, itchy skin and lifeless hair
  • White crusty deposits on taps and surfaces
  • Reduced lifespan of washing machines and dishwashers
Heat loss
12%
Heavy scaling
Softener salt
£17–29
per year
Worth it?
Yes
at 390 ppm
Suggested for very hard water
Whole-house water softener
Best long-term protection for boilers and pipes.
From £600 installed
Shower head filter
A simple first step for limescale on tiles and glass.
From £25
Filter jug or under-sink
Improves taste and reduces kettle scale.
From £20
Softening

Should you soften the water in Bury St Edmunds?

A verdict and running-cost estimate based on IP30's 390 ppm reading, for a typical 4-person household.

Softener recommended

Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Recommended size
32k
grain capacity, regenerates ~every 9.2 days
Salt running cost
£17–29
per year (~60 kg salt)
Limescale
12%
est. heater efficiency loss. Heavy scaling
Soap saving
High
Large saving: many homes cut soap, shampoo and detergent use by up to half.

Appliance impact at 390 ppm: significant: elements fur up, expect earlier failures. Sized for a 4-person home; regenerates roughly every 9 days (estimate). Figures are conservative estimates and vary with household size and usage.

Water quality details

Hardness data for IP30

Sourced from Anglian Water's published water-quality reports and public records.

Hardness measurements

Parts per million (ppm CaCO₃)390
Degrees Clark (°Clark)27.3
Degrees French (°fH)39
Degrees German (°dH)21.9
Calcium (mg/L Ca²⁺)156

Supplier and area

Water supplier Anglian Water
Region East Of England
County Suffolk
Hardness band Very Hard
UK average 207 ppm
Visit Anglian Water page
Official source
Anglian Water Services Ltd water-hardness report

Read the hard water explainer then use the linked postcode checker to confirm if you are in a hard water area; the region averages very hard.

Nearby

Other areas near Bury St Edmunds

IP29
Bury St Edmunds
366ppm
Very Hard
IP31
Bury St Edmunds
391ppm
Very Hard
IP32
Bury St Edmunds
392ppm
Very Hard
FAQ

Common questions about IP30

What is the water hardness in IP30 Bury St Edmunds?
The water in IP30 Bury St Edmunds has a hardness level of 390 ppm (parts per million) calcium carbonate, classified as very hard. This is 183 ppm above the UK national average of 207 ppm.
Which water company supplies IP30?
IP30 Bury St Edmunds is supplied by Anglian Water. Anglian Water serves the East Of England region.
Is the water in IP30 safe to drink?
Yes. Very Hard water at 390 ppm is safe to drink. Water hardness affects taste and can cause limescale, but it is not a health risk. In fact, hard water contains beneficial minerals like calcium and magnesium.
How can I reduce water hardness in IP30?
For very hard water at 390 ppm, a whole-house water softener is the most effective solution. You can also use a jug filter for drinking water, descaling products for appliances, and a shower filter for better skin and hair.
What does 390 ppm water hardness mean?
390 ppm means there are 390 parts per million of calcium carbonate dissolved in the water. This is equivalent to 27.3 Clark degrees, 21.9 German degrees, or 39 French degrees. Water above 180 ppm is generally considered hard.
What size water softener do I need in IP30?
For a typical 4-person home at 390 ppm, a 32,000 grain softener is a sensible size. It would regenerate roughly every 9.2 days. Larger households or higher daily use need a bigger unit. These figures are conservative estimates.
How much does it cost to run a water softener in IP30?
At 390 ppm, expect to use about 60 kg of salt a year, costing roughly £17–£29/year. Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Check another postcode

Compare hardness across areas before moving or buying a softener.