Water hardness

HP10 High Wycombe

Harder than the UK average. Expect visible limescale on kettles and taps.

At 252 ppm, High Wycombe sits among the UK's hardest water areas — compare it against the softest areas.

Hard 252 ppm South East Thames Water
Your reading
252
parts per million
Soft
Moderate
Hard
Very hard
0100200300400+

What this means for your home

Based on 252 ppm in High Wycombe (hard water).

  • Significant limescale buildup in kettles, pipes and boilers
  • Soap scum on shower screens and taps
  • Higher energy bills from scale in heating elements
  • Dry skin and dull hair after washing
  • White residue on dishes and glassware
Heat loss
8%
Moderate scaling
Softener salt
£14–25
per year
Worth it?
Yes
at 252 ppm
Suggested for hard water
Whole-house water softener
Best long-term protection for boilers and pipes.
From £600 installed
Shower head filter
A simple first step for limescale on tiles and glass.
From £25
Filter jug or under-sink
Improves taste and reduces kettle scale.
From £20
Softening

Should you soften the water in High Wycombe?

A verdict and running-cost estimate based on HP10's 252 ppm reading, for a typical 4-person household.

Softener recommended

Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Recommended size
24k
grain capacity, regenerates ~every 10.6 days
Salt running cost
£14–25
per year (~52 kg salt)
Limescale
8%
est. heater efficiency loss. Moderate scaling
Soap saving
Moderate
Noticeable saving: soaps lather more easily, cutting detergent use.

Appliance impact at 252 ppm: noticeable: boiler/dishwasher life cut without descaling. Sized for a 4-person home; regenerates roughly every 11 days (estimate). Figures are conservative estimates and vary with household size and usage.

Water quality details

Hardness data for HP10

Sourced from Thames Water's published water-quality reports and public records.

Hardness measurements

Parts per million (ppm CaCO₃)252
Degrees Clark (°Clark)17.6
Degrees French (°fH)25.2
Degrees German (°dH)14.1
Calcium (mg/L Ca²⁺)101

Supplier and area

Water supplier Thames Water
Region South East
County Hertfordshire
Hardness band Hard
UK average 207 ppm
Visit Thames Water page
Official source
Thames Water Utilities Ltd water-hardness report

Read the hardness categories table to see where your supply falls; most of the region is hard to very hard at over 200 mg/l CaCO3.

Nearby

Other areas near High Wycombe

HP9
Beaconsfield
326ppm
Very Hard
HP11
High Wycombe
253ppm
Hard
HP12
High Wycombe
254ppm
Hard
FAQ

Common questions about HP10

What is the water hardness in HP10 High Wycombe?
The water in HP10 High Wycombe has a hardness level of 252 ppm (parts per million) calcium carbonate, classified as hard. This is 45 ppm above the UK national average of 207 ppm.
Which water company supplies HP10?
HP10 High Wycombe is supplied by Thames Water. Thames Water serves the South East region.
Is the water in HP10 safe to drink?
Yes. Hard water at 252 ppm is safe to drink. Water hardness affects taste and can cause limescale, but it is not a health risk. In fact, hard water contains beneficial minerals like calcium and magnesium.
How can I reduce water hardness in HP10?
For hard water at 252 ppm, a whole-house water softener is the most effective solution. You can also use a jug filter for drinking water, descaling products for appliances, and a shower filter for better skin and hair.
What does 252 ppm water hardness mean?
252 ppm means there are 252 parts per million of calcium carbonate dissolved in the water. This is equivalent to 17.6 Clark degrees, 14.1 German degrees, or 25.2 French degrees. Water above 180 ppm is generally considered hard.
What size water softener do I need in HP10?
For a typical 4-person home at 252 ppm, a 24,000 grain softener is a sensible size. It would regenerate roughly every 10.6 days. Larger households or higher daily use need a bigger unit. These figures are conservative estimates.
How much does it cost to run a water softener in HP10?
At 252 ppm, expect to use about 52 kg of salt a year, costing roughly £14–£25/year. Water is hard to very hard, so appliance, scale and soap savings typically pay back a softener within a few years.

Fix hard water in High Wycombe

Enter your email and we will send the limescale fixes that actually work at 252 ppm, plus what to skip.

Check another postcode

Compare hardness across areas before moving or buying a softener.