Water hardness

CF39 Porth

Near or below the UK average. Limescale builds slowly.

At 109 ppm, Porth ranks near the UK's softest water areas — compare it against the hardest areas.

Slightly Hard 109 ppm Wales Welsh Water (Dwr Cymru)
Your reading
109
parts per million
Soft
Moderate
Hard
Very hard
0100200300400+

What this means for your home

Based on 109 ppm in Porth (slightly hard water).

  • Minor limescale may appear in kettles over time
  • Soap lathers reasonably well
  • Appliances generally unaffected
  • Good balance of mineral taste
Heat loss
4%
Light scaling
Softener salt
£6–11
per year
Worth it?
No
at 109 ppm
Suggested for slightly hard water
Filter jug (optional)
Mainly a taste preference, limescale won't be a real issue here.
From £20
Maintenance habits
Routine descaling once or twice a year is plenty.
Free
Softening

Should you soften the water in Porth?

A verdict and running-cost estimate based on CF39's 109 ppm reading, for a typical 4-person household.

Softener optional

Water is soft to moderate, so limescale and soap costs are low and a softener rarely pays back.

Recommended size
24k
grain capacity, regenerates ~every 24.6 days
Salt running cost
£6–11
per year (~22 kg salt)
Limescale
4%
est. heater efficiency loss. Light scaling
Soap saving
Low
Some saving: expect to use slightly less soap and detergent.

Appliance impact at 109 ppm: slight: minor descaling extends kettle/boiler life. Sized for a 4-person home; regenerates roughly every 25 days (estimate). Figures are conservative estimates and vary with household size and usage.

Water quality details

Hardness data for CF39

Sourced from Welsh Water (Dwr Cymru)'s published water-quality reports and public records.

Hardness measurements

Parts per million (ppm CaCO₃)109
Degrees Clark (°Clark)7.6
Degrees French (°fH)10.9
Degrees German (°dH)6.1
Calcium (mg/L Ca²⁺)44

Supplier and area

Water supplier Welsh Water (Dwr Cymru)
Region Wales
County Cardiff
Hardness band Slightly Hard
UK average 207 ppm
Visit Welsh Water (Dwr Cymru) page
Official source
Dwr Cymru Welsh Water water-hardness report

Read the hardness explanation here, then enter your postcode on the linked drinking water quality checker to see your area's calcium and magnesium levels.

Nearby

Other areas near Porth

CF38
Pontypridd
108ppm
Slightly Hard
CF40
Tonypandy
32ppm
Soft
CF41
Pentre
33ppm
Soft
FAQ

Common questions about CF39

What is the water hardness in CF39 Porth?
The water in CF39 Porth has a hardness level of 109 ppm (parts per million) calcium carbonate, classified as slightly hard. This is 98 ppm below the UK national average of 207 ppm.
Which water company supplies CF39?
CF39 Porth is supplied by Welsh Water (Dwr Cymru). Welsh Water (Dwr Cymru) serves the Wales region.
Is the water in CF39 safe to drink?
Yes. Slightly Hard water at 109 ppm is safe to drink. Water hardness affects taste and can cause limescale, but it is not a health risk. In fact, hard water contains beneficial minerals like calcium and magnesium.
How can I reduce water hardness in CF39?
At 109 ppm, the water in CF39 is slightly hard and unlikely to cause significant issues. A jug filter can improve taste, but a water softener is generally not necessary.
What does 109 ppm water hardness mean?
109 ppm means there are 109 parts per million of calcium carbonate dissolved in the water. This is equivalent to 7.6 Clark degrees, 6.1 German degrees, or 10.9 French degrees. Water above 180 ppm is generally considered hard.
What size water softener do I need in CF39?
For a typical 4-person home at 109 ppm, a 24,000 grain softener is a sensible size. It would regenerate roughly every 24.6 days. Larger households or higher daily use need a bigger unit. These figures are conservative estimates.
How much does it cost to run a water softener in CF39?
At 109 ppm, expect to use about 22 kg of salt a year, costing roughly £6–£11/year. Water is soft to moderate, so limescale and soap costs are low and a softener rarely pays back.

Check another postcode

Compare hardness across areas before moving or buying a softener.